Welcome to KEPSales.com
Call Us Toll Free:

1-877-268-3700

           

 

Online-Catalogs Available:

 

 

 

 

 

 

 

KEP Products Distributed By:
Gross Automation
1725 S. Johnson Road
New Berlin, WI

Zoids

 
ZOID-DC
 

PLC Operator Interface

Features
Description
  • Meets CE Mark requirements (DC powered units only)
  • 2 x 20 character, VFD or backlit LCD display
  • 24 VDC power (AC power optional)
  • 12 Programmable function keys (24 with shift keys)
  • 487 message capability
  • Serial interface for programming setup and printout

  • of messages
  • Multiple embedded variables per screen
  • Y2K Compliant Real time clock and calendar
KEP designed the ZOID DC to provide:
1. A convenient way for a machine operator to:
a. View machine status and parameters.

b. Change applicable parameters of operation
of a machine.
c. Maintain the running of a machine.
2. Enhanced capabilities to a machine through:

a. Real Time Clock access.

b. RS-232 ASCII output.
c. Direct keypad interface.
d. Visually displayed prompts.
The ZOID DC is designed to provide these features in a cost effective unit. It interfaces to the machine through a single cable (typically to a PLC programming port). The ZOID DC is a simple, easy-to-use interface that talks to your PLC directly through the programming port. Additional communications modules and cumbersome interface ladder logic are no longer necessary. Just plug in both ends of the cable and you are ready to go!
ZOID DC Data Sheet
(Size 107 Kilobytes)

 



 
K/PC
 

Keyboard Entry Device

Features
Description
 

  • 16 position raised tactile keyboard
  • 6 digit LED display
  • 8 line multiplexed input
  • 5 line binary output
  • 11 to 26 VDC operation
  • NEMA 4X / IP65 Front Panel
  • Screw terminal termination
The K/PC 9000 is a two way communications device. It has sixteen large, raised, tactile keys and a six digit, 0.55 inch high, 7 segment, LED display. It is intended to be used with standard low cost I/O modules and almost any programmable controller in use today. The K/PC 9000 enables the programmable controller user to input and read data, ask questions, make corrections and set and read parameters. Standard, low cost I/O modules are used for interface. Lines from output cards providing +3 to 27 volts DC may be used to drive the display section. Also lines to DC input cards may be used to interface the keypad. Since the keypad and the display are totally independent of each other, any desired method of reading and writing can be used, depending on the application. Special ASCII modules or shielded multiconductor cables are not required for interfacing the K/ PC 9000. When properly installed in an appropriate enclosure, the gasketed bezel will insure that the keypad meets NEMA 4 environmental requirements.
K/PC Data Sheet
(Size 27 Kilobytes)